DTC C1697: Camera Position Adjustment Incomplete [06/2018 - 09/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Lexus ES 350, 2022 Lexus ES 250, 2021 Lexus ES 350, 2021 Lexus ES 250, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT)
- Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
- Refer to camera view adjustment.
Refer to CALIBRATION [06/2018 - 09/2022]
Result
Proceed to NEXT - Refer to camera view adjustment.
Result:
NEXT
See step 2
- Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
- CHECK FOR DTC
- Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
- Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
OK
DTC C1697 is not output.
HINT:
- If DTC C1697 is output, perform the camera view adjustment again.
- If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.
Result
Proceed to OK NG
Result:
OK
END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE)
Result:
NG
REPLACE PARKING ASSIST ECU. Refer to REMOVAL [06/2018 - 09/2022]
- Clear the DTCs.