Precaution [08/2021 - 09/2022]

1. When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.

1. Before replacing any of the following parts, refer to Registration.

   Refer to REGISTRATION [08/2020 - 09/2022]

   • Certification ECU (smart key ECU assembly)
   • Electrical key transmitter sub-assembly
   • Main body ECU (multiplex network body ECU)
2. Electrical key and tire pressure monitoring system receiver assembly
   1. When replacing the electrical key and tire pressure monitoring system receiver assembly, read the transmitter IDs (tire pressure warning system) stored in the old ECU using the Techstream and write them down before removal.

      Refer to REGISTRATION [07/2019 - ]

   2. If the electrical key and tire pressure monitoring system receiver assembly has been replaced, it is necessary to perform initialization (Refer to INITIALIZATION [06/2018 - ] ) after registration (Refer to REGISTRATION [07/2019 - ] ) of the transmitter IDs to the electrical key and tire pressure monitoring system receiver assembly.

Refer to PRECAUTION [08/2021 - 09/2022]

1. Wireless door lock/unlock function:

   This wireless door lock control function operates only when the following 3 conditions are met:

   1. The engine switch is off.
   2. All of the doors are closed.*
      1. *: When the Wireless Lock Function with Doors Open customize setting is set to OFF
   3. The power door lock control system is operating properly.

      HINT: 

      The unlock function operates even when a door is open.

2. The size of the wireless door lock control operation area differs depending on the situation.
   1. The size of the operation area differs depending on the user and the way the electrical key transmitter sub-assembly is held.
   2. In certain areas, the wireless door lock control function will only operate partially for the operation area, which will be reduced due to the vehicle body shape and the influence of the surrounding environment.
   3. Since the electrical key transmitter sub-assembly uses weak radio waves, strong radio waves or electrical noise in the frequency used by the electrical key transmitter sub-assembly may reduce the size of the operation area and the remote control may not function.
   4. When the transmitter battery is weak, the size of the operation area is reduced and the remote control may not function.

      HINT: 

      • If the electrical key transmitter sub-assembly has been left in a place that is exposed to direct sunlight, such as on the instrument panel, it may cause the battery to be weakened or cause other related problems.
      • Do not place the electrical key transmitter sub-assembly near magnetic equipment, such as digital audio players, induction cookers, medical devices that generate low-frequency electromagnetic waves, etc.
3. Multi channel function

   The wireless door lock control system has a multi channel function. Each time the switch on the electrical key transmitter sub-assembly is pressed, the channel is switched alternately between 2 different frequencies and the signal is sent to the electrical key and tire pressure monitoring system receiver assembly.