DTC B1ACC-71: Rear Door Right Speaker Cable Actuator Stuck [09/2022 - ]: Procedure
- CHECK OPTIONAL COMPONENTS
- Check installed audio system and proceed to the following step.
Result
Result Proceed to w/o "Mark Levinson" sound system A w/ "Mark Levinson" sound system B
Result:
B
See step 5
Result:
A
See step 2
- Check installed audio system and proceed to the following step.
- CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - REAR SPEAKER ASSEMBLY RH)
- Disconnect the G11 stereo component amplifier assembly connector.
- Disconnect the M1 Rear speaker assembly RH connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G11-9 (RR+) - M1-2 (+) Always Below 1 Ω G11-24 (RR-) - M1-1 (-) Always Below 1 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 3
- INSPECT REAR SPEAKER ASSEMBLY RH
Refer to INSPECTION [06/2018 - ]
Result
Proceed to OK NG Result:
NG
REPLACE REAR SPEAKER ASSEMBLY RH. Refer to REMOVAL [06/2018 - ]
Result:
OK
See step 4
- CHECK FOR DTC
- Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
- In accordance with the display of the GTS, perform a speaker circuit energization inspection.
Refer to UTILITY [09/2022 - ]
Body Electrical > Navigation System > Utility
Tester Display Speaker Line Electricity Check - Check for DTCs and proceed to the following step.
Body Electrical > Navigation System > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC B1ACC-71 is output B
Result:
A
END (REAR SPEAKER ASSEMBLY RH IS DEFECTIVE)
Result:
B
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to REMOVAL [09/2022 - ]
- Clear the DTCs.
- CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - REAR SPEAKER ASSEMBLY RH)
- Disconnect the G11 stereo component amplifier assembly connector.
- Disconnect the M1 Rear speaker assembly RH connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G11-9 (RR+) - M1-2 (+) Always Below 1 Ω G11-24 (RR-) - M1-1 (-) Always Below 1 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 6
- REPLACE REAR SPEAKER ASSEMBLY RH
- Replace the speaker assembly with a new or known good one.
Refer to REMOVAL [06/2018 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 7
- Replace the speaker assembly with a new or known good one.
- CHECK FOR DTC
- Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
- In accordance with the display of the GTS, perform a speaker circuit energization inspection.
Refer to UTILITY [09/2022 - ]
Body Electrical > Navigation System > Utility
Tester Display Speaker Line Electricity Check - Check for DTCs and proceed to the following step.
Body Electrical > Navigation System > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC B1ACC-71 is output B
Result:
A
END (REAR SPEAKER ASSEMBLY RH IS DEFECTIVE)
Result:
B
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to REMOVAL [09/2022 - ]
- Clear the DTCs.