Inspection [06/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
- Measure the resistance according to the value(s) in the table below.
*a Valve Body *b Component without harness connected
(No. 1 Vacuum Switching Valve Assembly (for ACIS))Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 33 to 39 Ω 1 - No. 1 vacuum switching valve assembly (for ACIS) body ground Always 10 kΩ or higher 2 - No. 1 vacuum switching valve assembly (for ACIS) body ground If the result is not as specified, replace the No. 1 vacuum switching valve assembly (for ACIS).
- Check the No. 1 vacuum switching valve assembly (for ACIS) operation.
- When vacuum is applied to the port (E), check that air is sucked into the filter.
If the result is not as specified, replace the No. 1 vacuum switching valve assembly (for ACIS).
*a Filter *b Port (E) *c Air - Apply battery voltage across the terminals. When vacuum is applied to the port (F), check that air is sucked into the port (E).
If the result is not as specified, replace the No. 1 vacuum switching valve assembly (for ACIS).
*a Port (E) *b Port (F) *c Air
- When vacuum is applied to the port (E), check that air is sucked into the filter.
- Measure the resistance according to the value(s) in the table below.