LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Airbag System (Except Hybrid) - Diagnostics - Introduction) >> AIRBAG SYSTEM (for Gasoline Model) >> Check Mode Procedure [06/2018 - ] >> Check Mode Procedure [06/2018 - ]

Check Mode Procedure [06/2018 - ]

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK MODE (SIGNAL CHECK): DTC CHECK 
    1. Turn the engine switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / SRS Airbag / Utility / Signal Check.

      Body Electrical > SRS Airbag > Utility 

      Tester Display
      Signal Check
      NOTE:

      Select Signal Check on the Techstream to clear the DTCs (both current and history).

      HINT: 

      • DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
      • Perform check mode inspection when a malfunction in a squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.
scientia non olet · About LEMON Manuals