LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Engine Mechanical System (2GR-FKS) - Service Information (2 Of 3)) >> Front Crankshaft Oil Seal >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TIMING CHAIN CASE OIL SEAL 
    1. Apply MP grease to the lip of a new timing chain case oil seal.
      GTY673864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Oil Seal Protrusion Height
    2. Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.
      • SST: 09316-60012 
        1. 09316-00011

      Oil Seal Protrusion Height

      0 to 1.0 mm (0 to 0.0394 in.)

      NOTE:
      • Keep the lip free from foreign matter.
      • Do not tap in the timing chain case oil seal at an angle.
  2. INSTALL CRANKSHAFT PULLEY 
    1. Align the pulley set key with the key groove of the crankshaft pulley.
    2. Using SST to hold the crankshaft pulley in place, tighten the crankshaft pulley set bolt.
      GTY678152Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Hold
      Turn
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 

      Torque: 260 N.m (2651 kgf/cm, 192 ft.lbf) 

  3. INSTALL V-RIBBED BELT 

    Refer to PROCEDURE - Step 1

  4. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE 

    Refer to INSTALLATION [06/2018 - ] 

scientia non olet · About LEMON Manuals