Inspection [06/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT ENGINE SWITCH
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Engine Switch)Standard Resistance
Tester Connection Condition Specified Condition 5 (SS1) - 6 (AGND)
1 (SS2) - 6 (AGND)Not pushed 10 kΩ or higher Pushed Below 1 Ω If the result is not as specified, replace the engine switch.
- Measure the resistance according to the value(s) in the table below.
- Check the LED illumination.
- Apply battery voltage between the terminals of the engine switch and check the illumination condition of the engine switch indicator light.
OK
Condition Specified Condition Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)Illuminates HINT:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
- If the voltage is too low, the engine switch indicator light will not illuminate.
If the result is not as specified, replace the engine switch.
- Apply battery voltage between the terminals of the engine switch and check the illumination condition of the engine switch indicator light.
- Check the resistance.