DTC C1AEA: Steering Angle Midpoint Initial Setting Incomplete [06/2018 - 09/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Lexus ES 350, 2022 Lexus ES 250, 2021 Lexus ES 350, 2021 Lexus ES 250, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM CALIBRATION
- Perform steering angle neutral point memorization.
Refer to CALIBRATION [06/2018 - 08/2021] , or refer to CALIBRATION [08/2021 - 09/2022]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Perform steering angle neutral point memorization.
- CHECK FOR DTC
- Using the Techstream, check for DTCs according to the prompts on the screen.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
- Clear the DTCs according to the screen on the Techstream.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs
- Recheck for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
HINT:
- If DTC C1AEA is output, perform steering angle neutral point memorization.
- If DTC C1AEA is still output after performing steering angle neutral point memorization 3 times, replace the clearance warning ECU assembly.
Result
Result Proceed to DTC C1AEA is output A DTC C1AEA is not output B
Result:
A
REPLACE CLEARANCE WARNING ECU ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022]
Result:
B
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]
- Using the Techstream, check for DTCs according to the prompts on the screen.