DTC C164D: Wheel Speed Sensor Malfunction [06/2018 - 09/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Lexus ES 350, 2022 Lexus ES 250, 2021 Lexus ES 350, 2021 Lexus ES 250, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DTC OUTPUT
- Using the Techstream, check for DTCs according to the prompts on the screen.
HINT:
After turning the engine switch from off to on (IG), wait 4 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
- Clear the DTCs according to the screen on the Techstream.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs
- Recheck for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
HINT:
- DTC C164D is stored when a malfunction signal sent from the electronically controlled brake system is detected.
- If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C164D will not be output again.
- If DTC C164D is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
Result
Result Proceed to DTC C164D is output A DTC C164D is not output B
Result:
A
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]
Result:
B
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]
- Using the Techstream, check for DTCs according to the prompts on the screen.