LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Engine Control System (2GR-FKS) - Diagnostic Codes (07 Of 10)) >> SFI System >> DTC P0705-13: Transmission Range Sensor "A" Circuit Open; DTC P0705-62: Transmission Range Sensor "A" Signal Compare Failure [08/2021 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Inspect the fuses for circuits related to this system before performing the following procedure.

HINT: 

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. DATA LIST 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Data List / Shift SW Status (P Range), Shift SW Status (R Range), Shift SW Status (N Range), Shift SW Status (N, P Range), Shift SW Status (S Range) and Shift SW Status (D Range).

      Powertrain > Engine > Data List 

      Tester Display
      Shift SW Status (P Range)
      Shift SW Status (R Range)
      Shift SW Status (N Range)
      Shift SW Status (N, P Range)
      Shift SW Status (S Range)
      Shift SW Status (D Range)
    5. Read the values displayed on the Techstream.
      Techstream Display Measurement Item/Range Normal Condition Diagnostic Note
      Shift SW Status (P Range) Park/Neutral position switch assembly status:
      ON or OFF
      • ON: Shift lever in P
      • OFF: Shift lever not in P
      		 -
      Shift SW Status (R Range) Park/Neutral position switch assembly status:
      ON or OFF
      • ON: Shift lever in R
      • OFF: Shift lever not in R
      		 -
      Shift SW Status (N Range) Park/Neutral position switch assembly status:
      ON or OFF
      • ON: Shift lever in N
      • OFF: Shift lever not in N
      		 -
      Shift SW Status (N, P Range) Park/Neutral position switch assembly status:
      ON or OFF
      • ON: Shift lever in N or P
      • OFF: Shift lever not in N or P
      		 -
      Shift SW Status (S Range) Transmission control switch status:
      ON or OFF
      • ON: Shift lever in S
      • OFF: Shift lever not in S
      		 -
      Shift SW Status (D Range) Park/Neutral position switch assembly status:
      ON or OFF
      • ON: Shift lever in D or S
      • OFF: Shift lever not in D or S
      		 -
scientia non olet · About LEMON Manuals