DTC B2251: PBD/PTL Closer Switch [06/2018 - 08/2021]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG)
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Back Door / Trouble Codes.
5. Clear the DTCs.

   Body Electrical > Back Door > Clear DTCs 

6. Check for DTCs.

   Body Electrical > Back Door > Trouble Codes 

   OK

   DTC B2251 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

Result: 

NG 

See step  2

1. Enter the following menus: Body Electrical / Back Door / Data List.
2. Read the Data List according to the display on the Techstream.

   Refer to DATA LIST / ACTIVE TEST [06/2018 - 08/2021]

   Body Electrical > Back Door > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Half Latch SW	Luggage door closer assembly (half latch switch) signal	OFF or ON	ON: Luggage door closer assembly open-latched OFF: Luggage door closer assembly full-latched or half-latched	-
   Pawl Position Switch	Luggage door closer assembly (pawl switch) signal	OFF or ON	ON: Luggage door closer assembly half-latched OFF: Luggage door closer assembly except half -latched	-

   Body Electrical > Back Door > Data List 

   Tester Display
   Half Latch SW

   OK

   The Data List display changes according to luggage compartment door operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2021] 

Result: 

NG 

See step  3

1. Remove the luggage door closer assembly.

   Refer to REMOVAL [06/2018 - ]

2. Inspect the luggage door closer assembly. (Each switchs)

   Refer to INSPECTION [06/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE LUGGAGE DOOR CLOSER ASSEMBLY. Refer to  REMOVAL [06/2018 - ] 

Result: 

OK 

See step  4

1. Disconnect the R7 luggage closer motor assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   R7-7 (HAF) - R18-6 (FSW)	Always	Below 1 Ω
   R7-20 (PAWL) - R18-11 (CLS)	Always	Below 1 Ω
   R7-7 (HAF) or R18-6 (FSW) - Body ground	Always	10 kΩ or higher
   R7-20 (PAWL) or R18-11 (CLS) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2021] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR