DTC B2205: Kick Sensor Circuit [06/2018 - 08/2021]: Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Back Door / Trouble Codes.
- Clear the DTCs.
Body Electrical > Back Door > Clear DTCs
- Recheck for DTCs.
Body Electrical > Back Door > Trouble Codes
OK
DTC B2205 is not output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]
Result:
NG
See step 2
- CHECK FOR DTC
- Disconnect the S5 kick door control sensor connector.
- Wait for approximately 60 seconds.
- Clear the DTCs.
Body Electrical > Back Door > Clear DTCs
- Check for DTCs.
Body Electrical > Back Door > Trouble Codes
OK
DTC B2205 is not output.
Result
Proceed to OK NG
Result:
OK
REPLACE KICK DOOR CONTROL SENSOR. Refer to REMOVAL [06/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 08/2021]
Result:
NG
See step 3
- CHECK HARNESS AND CONNECTOR (LUGGAGE CLOSER MOTOR ASSEMBLY - KICK DOOR CONTROL SENSOR)
- Disconnect the R7 luggage closer motor assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition R7-24 (KSIN) or S5-3 (KSOT) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2021]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR