LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Safety Connect System (Except Hybrid) - Diagnostics - Introduction) >> SAFETY CONNECT SYSTEM (for Gasoline Model) >> ACN Call End [10/2019 - ] >> ACN Call End [10/2019 - ]

ACN Call End [10/2019 - ]

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. ACN CALL END 

    This function terminates the ACN (Automatic Collision Notification) to the telematics provider. After a collision in which the DCM receives "Collision Detection Signal", the vehicle will send the emergency call notification to the telematics provider until the emergency call cancellation utility has been run, or the mobilephone battery (if equipped) is depleted. Use the emergency call cancellation utility to stop the ACN call.

    NOTE:

    The mobilephone battery must not be replaced while an ACN call is in progress.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Choose "Telematics" from the System Selection Menu, and then click "Utility".
    5. Click "Emergency Call Cancellation " on the Utility Selection Menu.

      Body Electrical > Telematics > Utility 

      Tester Display
      Emergency Call Cancellation
    6. Follow the instructions on the Techstream.
scientia non olet · About LEMON Manuals