Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU [06/2018 - 09/2022]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Lexus ES 350, 2022 Lexus ES 250, 2021 Lexus ES 350, 2021 Lexus ES 250, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)
- Disconnect the G1 radio receiver assembly connector.
- Disconnect the G14 navigation ECU connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G1-7 (SUP) - G14-21 (SUP) Always Below 1 Ω G1-7 (SUP) or G14-21 (SUP) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [06/2018 - 10/2019] , or refer to PROBLEM SYMPTOMS TABLE [10/2019 - 08/2020] , or refer to PROBLEM SYMPTOMS TABLE [08/2020 - 08/2021] , or refer to PROBLEM SYMPTOMS TABLE [08/2021 - 09/2022]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR