LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System (2GR-FKS) - Service Information) >> Accelerator Pedal >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL ASSEMBLY 
    1. Engage the claw to install the accelerator pedal assembly.
      GTY787642Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 bolts.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

  2. INSTALL ACCELERATOR PEDAL PAD 
    1. Engage the 4 claws to install the accelerator pedal pad to the accelerator pedal assembly.
  3. INSTALL ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY 
    NOTE:
    • Avoid physical shock to the accelerator pedal sensor assembly.
    • Do not disassemble the accelerator pedal sensor assembly.
    • The accelerator pedal sensor assembly does not require lubrication.
    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
    1. Connect the rod of the accelerator pedal sensor assembly to the accelerator pedal assembly and install the accelerator pedal sensor assembly with the 3 nuts.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

    2. Connect the accelerator pedal sensor assembly connector.
  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 40 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 44 [08/2021 - ]

scientia non olet · About LEMON Manuals