Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT ENGINE MOUNTING INSULATOR

Install the stay to the front engine mounting insulator with the nut.
Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf)
Install the front engine mounting insulator to the front frame assembly with the 3 nuts.
Torque: 72 N.m (734 kgf/cm, 53 ft.lbf)

Install the front engine mounting bracket to the transaxle housing with the 3 bolts.

Bolt (A), (B) and (C)

Torque: 42 N.m (428 kgf/cm, 31 ft.lbf)

NOTE:

Temporarily tighten the bolt (A), and then fully tighten the 3 bolts in the order of (B), (C) and (A).

Install the front engine mounting bracket to the front engine mounting insulator with the bolt.
Bolt (D)

Torque: 72 N.m (734 kgf/cm, 53 ft.lbf)
Connect the vacuum hose to the front engine mounting insulator.
Engage the 2 clamps to install the vacuum hoses to the front engine mounting insulator.

INSTALL SUSPENSION TOWER DAMPER (w/ Performance Damper)
Refer to PROCEDURE - Step 1 [06/2018 - 08/2020] , or refer to PROCEDURE - Step 1 [08/2020 - ]
INSTALL NO. 3 ENGINE UNDER COVER
Refer to PROCEDURE - Step 69
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 70
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 71
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 72
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 47
INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
Refer to INSTALLATION [06/2018 - ]