LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Tire Pressure Warning System (Except Hybrid) - Diagnostic Codes & Symptom Tests) >> TIRE PRESSURE WARNING SYSTEM (for Gasoline Model) >> Tire Pressure Warning Light Circuit [06/2018 - ] >> Procedure

Tire Pressure Warning Light Circuit [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR DTC (CAN COMMUNICATION SYSTEM) 
    1. Check if CAN communication system DTCs are output.

      Refer to DIAGNOSIS SYSTEM [06/2018 - 10/2019] , or refer to DIAGNOSIS SYSTEM [10/2019 - 08/2020] , or refer to DIAGNOSIS SYSTEM [08/2020 - 08/2021] , or refer to DIAGNOSIS SYSTEM [08/2021 - 09/2022] , or refer to DIAGNOSIS SYSTEM [09/2022 - ]

      Result

      Result Proceed to
      DTCs are not output A
      DTCs are output B

    Result: 

    GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

    Result: 

    See step  2

  2. CHECK DTC OUTPUT (B1247) 
    1. Clear the DTCs.

      Chassis > Tire Pressure Monitor > Clear DTCs 

    2. Turn the engine switch off.
    3. Turn the engine switch on (IG).
    4. Check for DTCs.

      Chassis > Tire Pressure Monitor > Trouble Codes 

      Result

      Result Proceed to
      B1247 is not output A
      B1247 is output B

    Result: 

    GO TO DTC (B1247). Refer to  DTC B1247: Tire Pressure Monitor Receiver Communication Stop [06/2018 - ]  

    Result: 

    See step  3

  3. CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST) 
    1. Turn the engine switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    6. Check the condition of the tire pressure warning light using the Techstream.

      Body Electrical > Combination Meter > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Tire Pressure Warning System Indicator Tire pressure warning light OFF or ON -

      Body Electrical > Combination Meter > Active Test 

      Tester Display
      Tire Pressure Warning System Indicator

      OK

      The tire pressure warning light turns on or off in accordance with the Techstream operation.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER. Refer to  REMOVAL [06/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 - 09/2022]  , or refer to  REMOVAL [09/2022 - ] 

    Result: 

    NG 

    GO TO METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]