LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Lubrication System (2GR-FKS) - Service Information) >> Oil Pressure Switch >> Inspection [06/2018 - ] >> Procedure

Inspection [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disengage the clamp to disconnect the wire harness protector.
      GTY765569Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Wire Harness Protector
    2. Disconnect the engine oil pressure switch assembly connector.
    3. Start the engine.
    4. Measure the resistance according to the value(s) in the table below.
      GTY147711Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - Switch body Idling 10 kΩ or higher
      Engine stopped Below 1 Ω

      If the result is not as specified, replace the engine oil pressure switch assembly.

    5. Connect the engine oil pressure switch assembly connector.
    6. Engage the clamp to connect the wire harness protector.
scientia non olet · About LEMON Manuals