LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Automatic Transmission System (UA80E) - Service Information (2 Of 4)) >> Transmission Control Cable >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

      Torque: 6.0 N*m (1 kgf*cm, 53 in.*lbf) 

    2. Connect the transmission control cable assembly to the vehicle body with the 2 nuts.

      Torque: 6.0 N*m (1 kgf*cm, 53 in.*lbf) 

    3. Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
    4. Connect the transmission control cable assembly to the transmission control shaft lever as shown in the illustration.
      GTY765916Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Correct
      *b Incorrect
      NOTE:

      Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.

  2. INSTALL NO. 1 CONSOLE BOX DUCT 
    1. Install the No. 1 console box duct.
  3. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY 

    Refer to INSTALLATION [06/2018 - 01/2020] , or refer to INSTALLATION [01/2020 - 09/2022] , or refer to INSTALLATION [09/2022 - ] 

  4. INSTALL FRONT LOWER NO. 1 FLOOR HEAT INSULATOR 
    1. Install the front lower No. 1 floor heat insulator to the vehicle body with the 2 nuts.

      Torque: 4.9 N*m (0 kgf*cm, 43 in.*lbf) 

  5. INSTALL FRONT EXHAUST PIPE ASSEMBLY 

    Refer to INSTALLATION [06/2018 - ]

  6. INSTALL BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 41

  7. INSTALL ECM 

    Refer to INSTALLATION [06/2018 - ]

  8. INSTALL BATTERY 

    Refer to INSTALLATION [06/2018 - ]

  9. INSPECT SHIFT LEVER POSITION 

    Refer to PROCEDURE - Step 2 [06/2018 - 09/2022] , or refer to PROCEDURE - Step 2 [09/2022 - ]

  10. ADJUST SHIFT LEVER POSITION 

    Refer to ADJUSTMENT [06/2018 - 01/2020] , or refer to ADJUSTMENT [01/2020 - ] 

scientia non olet · About LEMON Manuals