DTC P0460-2A: Fuel Level Sensor "A" Signal Stuck In Range [06/2018 - 07/2019]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- INTERVIEW THE CUSTOMER
- Interview the customer for details about when the they refuel the vehicle.
HINT:
When the fuel tank is full, if the vehicle is repeatedly driven a short distance and then refueled, the fuel sender gauge output value will not change. In this case, the ECM may judge that the fuel sender gauge is stuck and store DTC P0460-2A. If the vehicle was driven in this manner, as the DTC was stored due to a user action, clear the DTCs without performing troubleshooting and return the vehicle to the customer.
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Interview the customer for details about when the they refuel the vehicle.
- INSPECT FUEL SENDER GAUGE ASSEMBLY
- Remove the fuel sender gauge assembly.
Refer to REMOVAL [06/2018 - 08/2021]
- Inspect the fuel sender gauge assembly.
Refer to INSPECTION [06/2018 - ]
Result
Proceed to OK NG
Result:
OK
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [06/2018 - ]
Result:
NG
REPLACE FUEL SENDER GAUGE ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2021]
- Remove the fuel sender gauge assembly.