On-Vehicle Inspection [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

CHECK STEERING EFFORT (TORQUE)
NOTE:
These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing.

Refer to PRECAUTION [06/2018 - 08/2020] , or refer to PRECAUTION [08/2020 - 09/2022] , or refer to PRECAUTION [09/2022 - ]
1. Stop the vehicle on a level, paved surface and align the wheels straight ahead.
2. Remove the horn button assembly.
  Refer to REMOVAL [06/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
3. Connect the cable to the negative (-) battery terminal.
4. Using a torque wrench, check that the steering wheel set bolt is properly tightened.
  Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf)
5. Start the engine so that the power steering is ready to operate.
6. Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same method.
  Standard Steering Effort (Reference)
  
  5.5 N*m (56 kgf*cm, 49 in.*lbf) or less
7. Align the front wheels facing straight ahead.
8. Turn the engine switch off.
9. Disconnect the cable from the negative (-) battery terminal.
  NOTE:
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Refer to INITIALIZATION [06/2018 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021] , or refer to INITIALIZATION [08/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - ]
10. Install the horn button assembly.
  Refer to INSTALLATION [06/2018 - 08/2020] , or refer to INSTALLATION [08/2020 - ]