LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Engine Cooling System (2GR-FKS) - Service Information) >> Water Pump >> Removal [06/2018 - 10/2019] >> Procedure

Removal [06/2018 - 10/2019]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 

    Refer to REMOVAL [06/2018 - 10/2019] 

  2. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [06/2018 - ]

  3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY 
    1. Remove the bolt and No. 2 idler pulley sub-assembly.
      GTY722079Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE WATER PUMP PULLEY 
    1. Using a screwdriver or equivalent with its tip wrapped in protective tape, hold the water pump pulley.
      GTY948837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Hold
      *c Turn
    2. Remove the 4 bolts and water pump pulley.
  5. REMOVE ENGINE WATER PUMP ASSEMBLY 
    1. Remove the 15 bolts, engine water pump assembly and water pump gasket.
      GTY768488Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals