LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Engine Cooling System (2GR-FKS) - Service Information) >> Thermostat >> Inspection [06/2018 - ] >> Procedure

Inspection [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Check the valve opening.

      HINT: 

      The valve opening temperature is inscribed on the water inlet with thermostat sub-assembly.

      GTY668827Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Add 15 cc (0.9 cu. in.) of water to the water inlet with thermostat sub-assembly from the inlet pipe side.
        GTY634529Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Inlet Pipe Side
        *b Valve Side
      2. Confirm that water does not flow out from the valve side of the water inlet with thermostat sub-assembly.

        If water flows out from the valve side of the water inlet with thermostat sub-assembly, replace the water inlet with thermostat sub-assembly with a new one.

      3. Immerse the water inlet with thermostat sub-assembly in water that is between 92°C (198°F) and 96°C (205°F) for 5 minutes or more.
        NOTE:
        • Do not allow any water to come into contact with the connector of the water inlet with thermostat sub-assembly.
        • Make sure that the end of the inlet pipe of the water inlet with thermostat sub-assembly is not facing downward.
        • Make sure to immerse the water inlet with thermostat sub-assembly in the water as shown in the illustration.
        GTY633309Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Connector
        *b Inlet Pipe
        Temperature Sensor
      4. Leave the water inlet with thermostat sub-assembly at ambient temperature for 5 minutes so that the valve closes.
        NOTE:

        Make sure that the end of the inlet pipe of the water inlet with thermostat sub-assembly is not facing downward.

        GTY649353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Inlet Pipe
      5. Check that the water that was added to the water inlet with thermostat sub-assembly has completely flowed out.

        If the water that was added to the water inlet with thermostat sub-assembly has not completely flowed out, replace the water inlet with thermostat sub-assembly with a new one.

    2. Check the resistance of the temperature sensor.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 Always 10.6 to 14.2 Ω

        If the result is not as specified, replace the water inlet with thermostat sub-assembly.

scientia non olet · About LEMON Manuals