LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Fuel System (2GR-FKS) - Service Information) >> Fuel Sender Gauge Assembly >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Engage the claw to install the fuel sender gauge assembly to the fuel sub-tank.
      NOTE:

      Be careful not to bend the arm of the fuel sender gauge assembly.

    2. Engage the 2 clamps to connect the wire harness to the fuel suction plate sub-assembly.
      NOTE:

      Do not damage the wire harness.

    3. Connect the fuel sender gauge assembly connector.
  2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [06/2018 - ] 

scientia non olet · About LEMON Manuals