LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Fuel System (2GR-FKS) - Service Information) >> FUEL PRESSURE SENSOR (for High Pressure) >> Removal [09/2022 - ] >> Procedure

Removal [09/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH) 

    Refer to REMOVAL [09/2022 - ] 

    NOTE:
    • Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.
    • If the fuel pressure sensor is removed, replace the fuel pressure sensor (fuel delivery pipe with sensor assembly LH) with a new one.
  2. REMOVE FUEL PIPE PLUG SUB-ASSEMBLY 
    1. Secure the fuel delivery pipe with sensor assembly LH in a vise between aluminum plates.
      NOTE:

      Do not overtighten the vise.

      GTY669090Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 5 mm hexagon socket wrench, remove the 2 bolts, gasket and fuel pipe plug sub-assembly from the fuel delivery pipe with sensor assembly LH.
    3. w/ Dust Cap:
      1. Remove the dust cap sub-assembly from the fuel pipe plug sub-assembly.
    4. Remove the O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring from the fuel pipe plug sub-assembly.
    5. Remove the fuel delivery pipe with sensor assembly LH from the vise.
scientia non olet · About LEMON Manuals