Removal [08/2016 - 08/2019]: Procedure

Refer to PROCEDURE - Step 1

See step  3

1. Disconnect the No. 2 parking brake wire assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the bolt and separate the No. 2 parking brake wire assembly from the rear axle carrier sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Remove the 3 bolts and separate the No. 2 parking brake wire assembly from the rear trailing arm assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the bolt and separate the rear speed sensor from the rear trailing arm assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.
   NOTE:

   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Wooden Block
   *b	Transmission Jack

2. Remove the 2 bolts and separate the rear lower shock absorber bracket sub-assembly from the rear axle carrier sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Remove the 4 bolts, 2 washers and rear trailing arm assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Temporarily install the rear lower shock absorber bracket sub-assembly to the rear axle carrier sub-assembly with the 2 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

5. Slowly lower the rear No. 2 suspension arm assembly.