Installation [08/2019 - ]: Procedure

INSTALL SUSPENSION TOWER DAMPER
1. Install the suspension tower damper to the frame side rail plate sub-assembly RH and frame side rail plate sub-assembly LH with the 4 nuts.
  Torque: 35 N*m (357 kgf*cm, 26 ft.*lbf)
  
  NOTE:
  Do not extend or compress the damper.
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 85
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 86
INSTALL NO. 3 ENGINE UNDER COVER
Refer to PROCEDURE - Step 87
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 88