Installation [10/2015 - ]: Procedure

1. Install the front stabilizer bar bushing LH to the front stabilizer bar as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout
   *b	Stopper
   	Front of the Vehicle
   	Inside of the Vehicle

   NOTE:

   • Install the front stabilizer bar bushing LH so that the cutout is facing the rear of the vehicle.
   • Install the front stabilizer bar bushing LH onto the front stabilizer bar so that the stopper ring of the front stabilizer bar faces the outside of the vehicle.

HINT: 

Perform the same procedure as for the LH side.

1. Install the front stabilizer bar with the 2 front stabilizer bar bushings to the vehicle body.
   NOTE:

   • Make sure that the identification mark is positioned as shown in the illustration.
   • Use wire or an equivalent tool to secure the front stabilizer bar.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark	-	-
   	Front of the Vehicle	-	-

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 4

1. Install the front No. 2 stabilizer bracket LH to the front frame assembly.
2. Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.

   Torque: 93 N*m (948 kgf*cm, 69 ft.*lbf) 

HINT: 

Perform the same procedure as for the LH side.

See step  [10/2015 - 08/2016], or see step  [08/2016 - 08/2019], or see step  [08/2019 - ]

Refer to PROCEDURE - Step 9

HINT: 

Perform the same procedure as for the LH side.

1. Install the front stabilizer link assembly LH to the front shock absorber assembly and front stabilizer bar with the 2 nuts.

   Torque: 76 N*m (775 kgf*cm, 56 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

HINT: 

Perform the same procedure as for the LH side.

Refer to PROCEDURE - Step 13

1. Engage the clamp and connect the hv floor under wire.

1. Engage the clamp and connect the oxygen sensor wire.

Refer to PROCEDURE - Step 82 [10/2015 - 08/2019] , or refer to PROCEDURE - Step 82 [08/2019 - ]

Refer to PROCEDURE - Step 1

Refer to ADJUSTMENT [10/2015 - 08/2016] , or refer to ADJUSTMENT [08/2016 - 03/2018] , or refer to ADJUSTMENT [03/2018 - ]