Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during oil cooler assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Replacement of front bumper assembly | Front television camera view adjustment | Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to CALIBRATION [08/2019 - ] for Calibration |
| Replacement of front bumper assembly (w/ Intelligent clearance sonar system) |
|
|
Refer to CALIBRATION [08/2019 - ] |