Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear upper control arm assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Rear wheel alignment adjustment | Calibration |
|
Refer to CALIBRATION [08/2019 - ] |
| Suspension, tires, etc. (The vehicle height changes because of suspension or tire replacement) |
|
|
Refer to CALIBRATION [08/2019 - ] |
| Rear television camera assembly optical axis (Back camera position setting) | Parking Assist Monitor System | for Initialization: Refer to INITIALIZATION [08/2019 - ] for Calibration: Refer to CALIBRATION [08/2019 - ] |
|
|
Panoramic View Monitor System | for Initialization: Refer to INITIALIZATION [08/2019 - ] for Calibration: Refer to CALIBRATION [08/2019 - ] |
|
| Initialize No. 1 headlight ECU sub-assembly LH | Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | |
| Rear height control sensor sub-assembly RH | Initialize No. 1 headlight ECU sub-assembly LH | Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] |
| Gas leak from exhaust system is repaired | Inspection After Repair |
|
Refer to INITIALIZATION [08/2019 - ] |
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | Refer to INITIALIZATION [08/2019 - ] |
| Pre-collision System | |||
| Intelligent Clearance Sonar System *1 | |||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | ||
| Parking Assist Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | Refer to INITIALIZATION [08/2019 - ] |
*1: When performing learning using the GTS.