LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> RX 350 Base, FWD >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension - Service Information (2 Of 2) >> Rear Shock Absorber >> Removal [08/2016 - 08/2019] >> Procedure

Removal [08/2016 - 08/2019]: Procedure

  1. REMOVE REAR WHEEL 

    Refer to PROCEDURE - Step 1

  2. REMOVE REAR SUSPENSION ARM COVER 

    See step  3

  3. REMOVE REAR SKID CONTROL SENSOR WIRE LH (w/ AVS) 
    1. Disconnect the 3 connectors.
      GTY648097Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt, 4 nuts and rear skid control sensor wire LH.
  4. REMOVE REAR SKID CONTROL SENSOR WIRE RH (w/ AVS) 
    1. Disconnect the 3 connectors and disengage the 3 clamps.
      GTY648093Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt, 4 nuts and rear skid control sensor wire RH.
  5. REMOVE REAR SHOCK ABSORBER ASSEMBLY (w/o AVS) 
    1. Using a jack and wooden block, support the rear No. 2 suspension arm assembly.
      NOTE:
      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
      • Make sure to perform this operation with the vehicle kept as low as possible.
      • Keep supporting the rear No. 2 suspension arm assembly with a jack until the installation of the rear shock absorber assembly has been completed.
      GTY680926Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Wooden Block
      *b Jack
      Wooden Block Placement Location
    2. Remove the 2 bolts, nut and the rear shock absorber assembly from the vehicle.
      GTY625096Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE REAR SHOCK ABSORBER ASSEMBLY (w/ AVS) 
    1. Using a jack and wooden block, support the rear No. 2 suspension arm assembly.
      NOTE:
      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
      • Make sure to perform this operation with the vehicle kept as low as possible.
      • Keep supporting the rear No. 2 suspension arm assembly with a jack until the installation of the rear shock absorber assembly has been completed.
      GTY680926Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Wooden Block
      *b Jack
      Wooden Block Placement Location
    2. Remove the 2 bolts, nut and the rear shock absorber assembly from the vehicle.
      GTY620352Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals