Installation [09/2015 - 08/2016]: Procedure

1. Install the rear upper coil spring insulator to the vehicle.

1. Install the rear lower coil spring insulator to the rear No. 2 suspension arm assembly.

1. Set the rear coil spring to the rear No. 2 suspension arm assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

   NOTE:

   Set the rear coil spring so that the identification mark is positioned as shown in the illustration.

2. Using a jack and wooden block, slowly jack up the rear No. 2 suspension arm assembly and then install the rear No. 2 suspension arm assembly to the rear axle carrier sub-assembly with the bolt and nut.

   Torque: 100 N*m (1020 kgf*cm, 74 ft.*lbf) 

   WARNING:

   Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

   NOTE:

   • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.
   • Insert the bolt with the threaded end facing the front of the vehicle.

1. Install the rear stabilizer link assembly to the rear stabilizer bar with the nut (B).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

2. Install the rear stabilizer link assembly to the rear No. 2 suspension arm assembly with the 2 nuts (A).

   Torque: 82 N*m (836 kgf*cm, 60 ft.*lbf) 

See step  8

Refer to INSTALLATION [09/2015 - 12/2017]

Refer to PROCEDURE - Step 1

See step  11

Refer to ADJUSTMENT [09/2015 - 08/2016]