Installation [08/2019 - ]: Procedure
- INSTALL SUSPENSION TOWER DAMPER
- Install the suspension tower damper to the vehicle with the 4 nuts.
Torque: 35 N*m (357 kgf*cm, 26 ft.*lbf)
NOTE:Do not extend or compress the damper.
- Install the suspension tower damper to the vehicle with the 4 nuts.
- INSTALL MAIN MUFFLER HEAT INSULATOR
- Install the main muffler heat insulator to the vehicle with the 4 nuts.
Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf)
- Install the main muffler heat insulator to the vehicle with the 4 nuts.
- INSTALL TAIL EXHAUST PIPE ASSEMBLY
Refer to INSTALLATION [12/2017 - ]
- INSPECT FOR EXHAUST GAS LEAK
Refer to PROCEDURE - Step 10