Caution / Notice / Hint
NOTE:
- When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
- Before performing the inspection, check that DTC B1242 (wireless door lock control) is not output.
- Before replacing the certification ECU (smart key ECU assembly) or main body ECU (multiplex network body ECU), refer to Registration.
Refer to REGISTRATION [09/2014 - 03/2019] , or refer to REGISTRATION [03/2019 - 09/2020] , or refer to REGISTRATION [09/2020 - 01/2023] , or refer to REGISTRATION [01/2023 - ]
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".