Caution / Notice / Hint

NOTE:

If the vehicle speed is outside the allowable range when tested, perform the on-vehicle inspection.
Refer to ON-VEHICLE INSPECTION [09/2014 - 10/2015] , or refer to ON-VEHICLE INSPECTION [10/2015 - 11/2017]
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

HINT:

Before starting the following inspection, check tire size and tire air pressure.
Active Test cannot be performed on the speedometer for TFT meter type.