LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> NX 300h >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) >> Multi-Display >> Removal [05/2019 - ] >> Procedure

Removal [05/2019 - ]: Procedure

  1. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2

  3. REMOVE REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 3

  4. REMOVE DECK FLOOR BOX LH 

    Refer to PROCEDURE - Step 4

  5. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before serving.

    Refer to PRECAUTION [05/2019 - ]

    NOTE:

    After turning the power switch off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

    Refer to PRECAUTION [05/2019 - ]

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
    • If the airbag deploys for any reason. it may cause a serious accident.
  7. REMOVE INSTRUMENT PANEL FINISH PLATE 

    Refer to PROCEDURE - Step 19

  8. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET 
    1. for 8 inch:
      GTY777876Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts.
      2. Move the multi-display assembly with bracket as indicated by the arrow shown in the illustration to detach the 2 clips.
        GTY777880Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Detach the 3 guides.
        GTY813382Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Disconnect the 3 connector.
        GTY777884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      5. Detach the clamp and remove the multi-display assembly with bracket.
    2. for 10.3 inch:
      GTY827888Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts.
      2. Move the multi-display assembly with bracket as indicated by the arrow shown in the illustration to detach the 2 clips.
        GTY777877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Detach the 3 guides.
        GTY813383Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Disconnect the 3 connector.
        GTY827887Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      5. Detach the clamp and remove the multi-display assembly with bracket.
  9. REMOVE MULTI-DISPLAY CONTROLLER BRACKET A 
    1. for 8 inch:
      1. Remove the 2 screws.
        GTY777885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the 2 screws and multi-display controller bracket A.
        GTY827886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for 10.3 inch:
      1. Remove the 2 screws.
        GTY775193Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the 2 screws and multi-display controller bracket A.
        GTY775194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE MULTI-DISPLAY ASSEMBLY 
scientia non olet · About LEMON Manuals