Pointer does not Reach Screen Edge [10/2014 - 09/2017]: Procedure

1. Check if there is any foreign matter around the remote touch screen that interferes with operation of the screen.

   OK

   There is no foreign matter around the remote touch screen that interferes with operation of the screen.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REMOVE FOREIGN MATTER (CHECK OPERATION AGAIN) 

Result: 

OK 

See step  2

1. Enter the "Remote Touch Switch Check" screen. Refer to Check Remote Touch Switch in Operation Check.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Pointer
   *b	Coordinate
   *c	"+" Mark

   Refer to OPERATION CHECK [10/2014 - 09/2017]

2. When the remote touch screen is pressed or double tapped, the "+" mark is displayed in any blank space on the screen.

   HINT: 

   • The "+" mark is displayed at the pointer position when the touch screen is pressed or double tapped.
   • Even if the pointer is moved, the "+" mark will remain at the position where the pointer was when the touch screen was pressed or double tapped.
3. Operate the remote touch screen switch to move the pointer. When the location of the pointer is changed by operating the touch screen, check that the coordinate values "X" and "Y" change between 5 and 250.

   Result

   Result	Proceed to
   Remote touch switch check cannot be performed due to a remote touch screen malfunction.	A
   The coordinate values "X" and "Y" do not change between 5 and 250 according to the location of the pointer.
   The coordinate values "X" and "Y" change between 5 and 250 according to the location of the pointer.	B

Result: 

B 

REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017] 

Result: 

A 

See step  3

1. Enter self-diagnostic mode.

   Refer to OPERATION CHECK [10/2014 - 09/2017]

2. Operate the remote touch screen diagonally from the lower left to the upper right and check that the brightness of the switch illumination changes.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Switch Illumination
   *b	Touch Screen

   NOTE:

   Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch in self-diagnostic mode.

   OK

   Brightness changes according to touch screen operation.

   Result

   Result	Proceed to
   Brightness of the switch illumination changes according to remote touch screen operation.	A
   Brightness of the switch illumination does not change according to remote touch screen operation.	B
   Switch illumination continues to blink.

   HINT: 

   When the switch illumination blinks, the remote touch has stored a DTC.

Result: 

A 

REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017] 

Result: 

B 

See step  4

1. Replace the remote operation controller assembly.

   Refer to REMOVAL [10/2014 - 09/2017]

2. Check that the pointer moves to the edge of the screen.

   OK

   The pointer moves to the edge of the screen.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (REMOTE OPERATION CONTROLLER ASSEMBLY IS DEFECTIVE) 

Result: 

NG 

REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017]