Removal [10/2014 - 09/2017]: Procedure

DISABLE AUTOAWAY/RETURN FUNCTION
1. Disable the autoaway/return function by changing the customize parameter.
  Refer to CUSTOMIZE PARAMETERS [10/2014 - ]
  
  WARNING:
  Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.
  
  HINT:
  
  Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.
2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
3. Turn the power switch off.
REMOVE CONSOLE ARMREST ASSEMBLY
Refer to PROCEDURE - Step 8
REMOVE UPPER REAR CONSOLE PANEL
Refer to PROCEDURE - Step 9
REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
Refer to PROCEDURE - Step 10
REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
Refer to PROCEDURE - Step 11
REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 12
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 13
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 14
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 15
REMOVE NO. 1 SWITCH HOLE BASE
Refer to PROCEDURE - Step 16
REMOVE INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 17
REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 18
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 19
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 20

REMOVE COMBINATION METER ASSEMBLY

Remove the 4 screws.

Screw

Disconnect the connectors, detach the clamp and remove the combination meter assembly.