LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> NX 300 Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission (U661E) - Service Information (1 Of 2)) >> Shift Paddle Switch >> Installation [09/2017 - ] >> Procedure

Installation [09/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Engage the 6 guides to install the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire to the steering wheel assembly.
    2. Connect the 2 shift paddle switch (transmission shift switch assembly) connectors to install the 2 shift paddle switches (transmission shift switch assemblies) to the No. 1 switch wire.
    3. Install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly with 4 new screws.
    4. Connect the No. 1 switch wire connector.
    5. Engage the guide to connect the No. 1 switch wire to the steering wheel assembly.
  2. INSTALL STEERING PAD SWITCH ASSEMBLY 

    Refer to PROCEDURE - Step 1

  3. INSTALL CRUISE CONTROL MAIN SWITCH 

    Refer to PROCEDURE - Step 1

  4. INSTALL STEERING WHEEL ASSEMBLY 

    Refer to INSTALLATION [09/2017 - ]

scientia non olet · About LEMON Manuals