Inspection [10/2014 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Transmission Shift Switch Assembly LH)Standard Resistance
TRANSMISSION SHIFT SWITCH ASSEMBLY LH:Tester Connection Switch Condition Specified Condition SDN - ECC "-" shift paddle operated and held
(down-shift)Below 2.5 Ω "-" shift paddle not operated
(down-shift)1 MΩ or higher If the resistance values are not as specified, replace the transmission shift switch assembly LH.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
TRANSMISSION SHIFT SWITCH ASSEMBLY RH:Tester Connection Switch Condition Specified Condition SUP - ECC "+" shift paddle operated and held
(up-shift)Below 2.5 Ω "+" shift paddle not operated
(up-shift)1 MΩ or higher *a Component without harness connected
(Transmission Shift Switch Assembly RH)If the resistance values are not as specified, replace the transmission shift switch assembly RH.
- Measure the resistance according to the value(s) in the table below.
- INSPECT NO. 1 SWITCH WIRE
- Disconnect the No. 1 switch wire connector from the steering pad switch assembly.
- Measure the resistance according to the value(s) in the table below.
*a No. 1 switch wire
(to Steering Pad Switch Assembly)Standard Resistance
Tester Connection Switch Condition Specified Condition z7-2 (SDN) - z7-3 (ECC) "-" shift paddle operated and held
(down-shift)Below 2.5 Ω "-" shift paddle not operated
(down-shift)1 MΩ or higher z7-1 (SUP) - z7-3 (ECC) "+" shift paddle operated and held
(up-shift)Below 2.5 Ω "+" shift paddle not operated
(up-shift)1 MΩ or higher If the resistance value is not as specified, replace the No. 1 switch wire.