Installation [10/2014 - 09/2017]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (PATTERN SELECT SWITCH)

Install the integration control and panel assembly (pattern select switch) to the rear upper console panel sub-assembly with the 2 screws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

The locations labeled A in the illustration are tightened together with the shift position indicator.

INSTALL SHIFT POSITION INDICATOR
See step 1
INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 15
INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 16
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 17
INSTALL NO. 1 SWITCH HOLE BASE
Refer to PROCEDURE - Step 18
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 19
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 20
INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 21
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 22
INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
Refer to PROCEDURE - Step 23
INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH
Refer to PROCEDURE - Step 24
INSTALL REAR UPPER CONSOLE PANEL
Refer to PROCEDURE - Step 25
INSTALL CONSOLE ARMREST ASSEMBLY
Refer to PROCEDURE - Step 26