Inspection [10/2014 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (PATTERN SELECT SWITCH)
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Integration Control and Panel Assembly (Pattern Select Switch))Standard Resistance
Tester Connection Switch Condition Specified Condition 7 (P) - 1 (GND) SPORT or SPORT S/S+ mode switch turned and held at SPORT or SPORT S/S+ position Below 10 Ω 7 (P) - 1 (GND) SPORT or SPORT S/S+ mode switch not turned 1 MΩ or higher 8 (B) - 1 (GND) NORMAL mode switch pushed and held Below 10 Ω 8 (B) - 1 (GND) NORMAL mode switch not pushed 1 MΩ or higher If the result is not as specified, replace the integration control and panel assembly (pattern select switch).
- Apply battery voltage between the terminals of the switch, and check the illumination condition of the integration control and panel assembly (pattern select switch).
Standard
Measurement Condition Specified Condition Battery positive (+) → 10 (ILL+) Battery negative (-) → 6 (ILL-) Illuminates If the result is not as specified, replace the integration control and panel assembly (pattern select switch).
- Measure the resistance according to the value(s) in the table below.