Installation [10/2014 - ]: Procedure

1. Align the protrusions of the park/neutral position switch assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protrusion

2. Install the park/neutral position switch assembly to the manual valve lever shaft sub-assembly with the 2 bolts.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

   NOTE:

   • Before installing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.
   • After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.
3. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the nut and washer.

   Torque: 12.7 N.m (130 kgf/cm, 9 ft.lbf) 

4. Connect the connector to the park/neutral position switch.

1. Connect the transmission control cable assembly to the transmission control shaft lever with the nut.

   Torque: 12 N.m (122 kgf/cm, 9 ft.lbf) 

   NOTE:

   Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.

Refer to PROCEDURE - Step 4 [10/2014 - 05/2019] , or refer to PROCEDURE - Step 4 [05/2019 - ]

Refer to PROCEDURE - Step 6 [10/2014 - 05/2019] , or refer to PROCEDURE - Step 6 [05/2019 - ]

See step  1

Refer to ADJUSTMENT [10/2014 - ]