Removal [05/2019 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECAUTION WARNING:
Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [05/2019 - ]
NOTE:After the engine switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Refer to PRECAUTION [05/2019 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
- REMOVE BATTERY CLAMP SUB-ASSEMBLY
Refer to PROCEDURE - Step 4
- REMOVE BATTERY INSULATOR
- REMOVE BATTERY
- REMOVE BATTERY TRAY
- REMOVE BATTERY CARRIER ASSEMBLY
Refer to PROCEDURE - Step 8
- REMOVE BATTERY BRACKET REINFORCEMENT
Refer to PROCEDURE - Step 9
- REMOVE NO. 1 ENGINE UNDER COVER (for Sport Package)
Refer to PROCEDURE - Step 6
- REMOVE REAR ENGINE UNDER COVER LH
Refer to PROCEDURE - Step 9
- DRAIN AUTOMATIC TRANSAXLE FLUID
See step 3
- DRAIN ENGINE COOLANT
Refer to PROCEDURE - Step 1
- REMOVE OIL COOLER HOSE
- REMOVE WATER BY-PASS HOSE
- Detach the clamp from the No. 5 water by-pass hose.
- Slide the 4 clips and remove the No. 5 water by-pass hose and No. 6 water by-pass hose.
*1 No. 5 Water By-pass Hose *2 No. 6 Water By-pass Hose NOTE:Use a container to catch any coolant which flows out of the No. 5 water by-pass hose, No. 6 water by-pass hose.
- Detach the clamp from the No. 5 water by-pass hose.
- REMOVE TRANSMISSION OIL COOLER