Installation [10/2014 - ]: Procedure

1. Remove any oil from the threads of the oil pressure sender gauge assembly.
2. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

   Adhesive

   TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.

   NOTE:

   Do not let adhesive adhere to the oil hole.

3. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   NOTE:

   Do not start the engine within 1 hour of installation.

4. Connect the oil pressure sender gauge assembly connector.

See step   [10/2014 - 05/2018] , or see step   [05/2018 - ]