LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> NX 300 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Service Information >> Multi-Display >> Installation [05/2019 - ] >> Procedure

Installation [05/2019 - ]: Procedure

  1. INSTALL MULTI-DISPLAY ASSEMBLY 
  2. INSTALL MULTI-DISPLAY CONTROLLER BRACKET A 
    1. for 8 inch:
      1. Temporarily install the multi-display controller bracket A with the 2 screws.
        GTY827886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Install the 2 screws and tighten the 2 screws used to temporarily install the bracket.
        GTY777885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for 10.3 inch:
      1. Temporarily install the multi-display controller bracket A with the 2 screws.
        GTY775194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Install the 2 screws and tighten the 2 screws used to temporarily install the bracket.
        GTY775193Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET 
    1. for 8 inch:
      1. Connect the 3 connector and attach the clamp.
        GTY777884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Set the 3 guides.
        GTY813382Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Move the multi-display assembly with bracket as shown in the illustration to attach the 2 clips.
        GTY777929Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Install the 2 bolts and multi-display assembly with bracket.
        GTY777876Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for 10.3 inch:
      1. Connect the 3 connector and attach the clamp.
        GTY827887Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Set the 3 guides.
        GTY813383Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Move the multi-display assembly with bracket as shown in the illustration to attach the 2 clips.
        GTY827897Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Install the 2 bolts and multi-display assembly with bracket.
        GTY827888Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL INSTRUMENT PANEL FINISH PLATE 

    Refer to PROCEDURE - Step 16

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL 

    Refer to WORK PROCEDURE [05/2019 - ]

    HINT: 

    When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [05/2019 - ]

scientia non olet · About LEMON Manuals