LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> LS 500h RWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension System (Front) - Service Information (2 Of 2) >> Front Stabilizer Bar >> Installation [10/2023 - ] >> Procedure

Installation [10/2023 - ]: Procedure

  1. INSTALL FRONT STABILIZER BAR 
    1. Install the front stabilizer bar with the 4 bolts.

      Torque: 120 N.m (1224 kgf/cm, 89 ft.lbf) 

      NOTE:

      Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).

      GTY823334Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT STABILIZER LINK ASSEMBLY LH 
    1. Install the front stabilizer link assembly LH to the lower No. 2 suspension arm assembly LH and front stabilizer bar with the 2 nuts.

      Torque: 150 N.m (1530 kgf/cm, 111 ft.lbf) 

      HINT: 

      If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.

  3. INSTALL FRONT STABILIZER LINK ASSEMBLY RH 

    HINT: 

    Perform the same procedure as for the LH side.

  4. INSTALL STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 113

  5. INSTALL FRONT SUSPENSION MEMBER BRACE 

    Refer to PROCEDURE - Step 114

  6. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 115

  7. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 117

  8. INSTALL FRONT WHEEL 

    Refer to INSTALLATION [10/2023 - ]

scientia non olet · About LEMON Manuals