Removal [10/2020 - 11/2021]: Procedure

DRAIN BRAKE FLUID
NOTE:
If brake fluid leaks onto any painted surface, immediately wash it off.
DISCONNECT BRAKE BOOSTER PUMP CONNECTOR (w/o Advanced Park)
Refer to PROCEDURE - Step 3
DISABLE BRAKE CONTROL (w/ Advanced Park)
Refer to PROCEDURE - Step 2
REMOVE FRONT WHEEL
Refer to REMOVAL [10/2017 - 10/2023]

REMOVE FRONT DISC BRAKE PAD

WARNING:

Be careful not to get pinched by the disc brake cylinder assembly or other parts when removing the front disc brake pads.

NOTE:

Be sure to inspect the front disc when replacing the front disc brake pads with new ones.

for RH side:

Disconnect the front pad wear indicator wire connector assembly RH from the front skid control sensor wire.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the clamp (A) from the front disc brake dust cover RH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

While pressing the area (A), push the hole pin (B) toward the disk brake cylinder assembly LH, and remove the pin hold clip.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

While pressing the area (A), remove the 2 hole pins (B) and No. 1 anti-rattle spring.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 front disc brake pads from the disk brake cylinder assembly LH.

for RH side:

Detach the pad wear indicator retainer and remove the pad wear indicator wire assembly RH from the front disc brake pad.

REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM

Remove the No. 1 and No. 2 anti-squeal shims from each of the front disc brake pads.