Removal [10/2023 - ]: Procedure

Refer to REMOVAL [10/2023 - ]

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Using SST, hold the crankshaft pulley.

   • SST: 09213-70011 
     1. 09213-70020
   • SST: 09330-00021 
2. Remove the 9 bolts and transmission input damper cover assembly from the flywheel sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09213-70011 
     1. 09213-70020
   • SST: 09330-00021 
2. Remove the 8 bolts and flywheel sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cut Position
   *b	Protective Tape

   Using a knife, cut through the lip of the rear engine oil seal.

2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
   NOTE:

   Be careful not to damage the crankshaft.