LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> LS 500h AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical System - Service Information (2 Of 5) >> Rear Crankshaft Oil Seal >> Removal [10/2020 - 11/2021] >> Procedure

Removal [10/2020 - 11/2021]: Procedure

  1. REMOVE HYBRID VEHICLE TRANSMISSION ASSEMBLY 
    1. for 2WD:

      Refer to REMOVAL [10/2020 - 10/2022]

    2. for AWD:

      Refer to REMOVAL [10/2020 - 11/2021]

  2. REMOVE TRANSMISSION INPUT DAMPER COVER ASSEMBLY 
    1. GTY816121Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Using SST, hold the crankshaft pulley.

      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 
    2. Remove the 9 bolts and transmission input damper cover assembly from the flywheel sub-assembly.
      GTY828152Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FLYWHEEL SUB-ASSEMBLY 
    1. Using SST, hold the crankshaft pulley.
      GTY816121Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 
    2. Remove the 8 bolts and flywheel sub-assembly.
      GTY779085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE OIL SEAL 
    1. GTY804990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Cut Position
      *b Protective Tape

      Using a knife, cut through the lip of the rear engine oil seal.

    2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
      NOTE:

      Be careful not to damage the crankshaft.

scientia non olet · About LEMON Manuals